AW-ID0827-9 0.7-2.7 GHz Indoor DAS Antenna (9 dBi)
0.7-2.7 GHz indoor das antenna — 9 dBi gain, vertical polarization, N-Female connector.
AW-ID0827-9 specifications
Model
AW-ID0827-9
Frequency Range
698–2700 MHz
Gain
9 dBi
Polarization
Vertical
Half-Power Beamwidth
90° (H) × 60° (V)
Dimensions
295 × 205 × 65 mm
Connector
N-Female
Impedance
50 Ω
VSWR
≤ 1.5:1
Power Handling
100 W
Ingress Protection
IP40
Material / Radome
Fire-rated ABS
The AW-ID0827-9 is a 0.7-2.7 GHz indoor das antenna engineered for in-building das. It delivers 9 dBi of gain with vertical polarization, making it a dependable choice where consistent 0.7-2.7 GHz performance is required.
Radiation Pattern and Gain
The half-power beamwidth is approximately 90 degrees in azimuth by 60 degrees in elevation, concentrating radiated energy toward the intended service area and improving signal-to-noise ratio at the cell edge. The rated gain of 9 dBi is referenced to an isotropic radiator.
Mechanical and Electrical Specifications
Mechanically, the AW-ID0827-9 measures 295 x 205 x 65 mm and is housed in a Fire-rated ABS. The standard interface is a N-Female connector, with a nominal impedance of 50 ohms and a typical VSWR of 1.5:1 or better. The element withstands up to 100 W of input power.
Installation Guidance
The recommended installation is indoor, wall-mounted. The enclosure carries an IP40 environmental rating for outdoor exposure. For best results, mount the antenna with clear line of sight to the served area and bond all outdoor hardware to a proper grounding system.
Typical Applications
In-Building DAS
In-Building Coverage
Request a Quote
Need this antenna with a custom connector, cable length, or radome color? Use the antenna configurator to confirm the specification and submit an inquiry for AW-ID0827-9.
Advanced filters (dimension limits)
Frequently Asked Questions
What is a indoor das antenna used for?
Ceiling dome and wall-panel antennas for in-building distributed antenna systems (DAS).
Is AW-ID0827-9 suitable for in-building das?
Yes. AW-ID0827-9 is well matched to in-building das deployments, where its radiation pattern and gain provide reliable coverage and link margin.
Can the connector on AW-ID0827-9 be changed?
Yes. The default RF interface can be supplied as SMA, N-type, TNC, or other connectors on request, and custom cable assemblies are available. Specify your interface in the inquiry form.
What is the standard impedance and VSWR of AW-ID0827-9?
The nominal impedance is 50 ohms with a typical VSWR of 1.5:1 or better across the operating band. A 75 ohm option can be quoted for broadcast applications.
How do I request a quote for AW-ID0827-9?
Use the antenna configurator on this page to confirm the specification, then submit the inquiry form. An engineer from astronwireless.com will respond within one business day.
Accessories & Components
Complete your installation with matched RF cables, connectors, mounts, adapters and bulk coaxial cable. Custom assemblies, lengths and interfaces are available on request.
